Maintenance of the fuck dolls

The maintenance of the fuck dolls is relatively fine, and we elaborate from the two aspects of prohibited matters and how to deal with problems.

1. Prohibited items

(1) It is forbidden to place difficult positions for a long time: the doll is in a straight posture when it leaves the factory, and placing difficult actions for a long time will lead to deformation and damage of the rubber material. Be sure to return to the original state after use, that is, let the doll lie on its back with hands hanging at the sides of the body (do not let the doll stand for a long time if it is not a standing model);

(2) It is forbidden to use sharp instruments to scratch the skin surface and knead hard to avoid damage to the skin;

(3) It is forbidden to place the doll in direct sunlight for a long time, so as not to cause deterioration of the rubber material;

(4) Try not to wear clothes and accessories that fade easily.

2, how to maintain the problem

(1) What if it gets dirty?

Step 1: Cool water/warm water, use laundry detergent, body wash or special cleaning agent for cleaning, strictly prohibit alcohol cleaning, boiling water (will destroy the coating);

Step 2: Let dry after washing. Use towels, paper towels to dry the water, do not use a hair dryer;

Step 3: Evenly apply the hand powder (which can be replaced by ordinary prickly heat powder) to the surface.

(2) What if there is a tear?

Determine the size of the tear. Small area cracks can be repaired by themselves, and larger cracks are recommended to contact the seller or manufacturer. Repair steps for small area cracks are as follows:

Step 1: Clean the damaged surface and let it dry;

Step 2: Restore the adhesive material to its original position, and then evenly apply a layer of repair agent (glue);

Step 3: Rest for more than 30 minutes, and wait for it to dry.

The principle of the repair agent (glue) is that in the repair process, the glue around the damaged part is melted first (harmless to the human body), and then the damaged part is re-fused. Normal operation will not affect the appearance of the repair, but if you do not close the broken wound and apply the repair agent, then you should wipe the repair agent with a damp cloth and paper towel, restore the original position, and then repair. Otherwise, continuing to apply without removing the remedy will cause the colloid around the tear to melt even more.

(3) What if it is dyed?

A color remover for TPE thermoplastic elastomers can remove local staining over a period of time (non-toxic and harmless to the human body).

Step 1: According to the size and degree of dyeing, take an appropriate amount of ointment with a cotton swab and evenly apply it to the dyed part;

Step 2: Repeat every 4 hours until completely removed.

However, it needs to be emphasized that the color removal cream can only slow down the dyeing to varying degrees, that is, the use of heavy coloring cream can make the color lighter, but can not be completely removed. Under normal circumstances, small area dyeing will complete the fading within 24 hours, and serious dyeing is generally removed within 3-4 days.